Arctic

Arctic P14 PWM PST Pressure-Otimised 140mm Case Fan

SALE
分類: 風扇
價格:$84

貨品介紹

Optimised for Static Pressure

During the development of the new P14 PWM, special emphasis was placed on a focused airstream and thus a high static pressure. The fan guarantees extremely efficient cooling, even with increased air resistance. Therefore, the P14 PWM is particularly suitable for use on heatsinks and radiators.

 

More Efficient Technology

The motor is powered by a Neodym-Iron-Boron-Magnet ring of the newest generation, which allows the new P14 PWM to run much more efficiently than its predecessors. This saves energy and lowers the coil temperature without comprimising the performance.

P14 PWM
F14 PWM

Power Consumption

1.44 W @ 1700 RPM
3.6 W @ 1350 RPM
 

Maximum Quietness, Minimum Vibration

Even at low speeds the operating sound of the new ARCTIC motor is barely noticeable.
Due to a sinus-magnetizing the new motor only creates about 5 % of the vibration from commutation of a regular DC-motor without filter. Consequently, there is no need for rubber spacers due to the steady and smooth torque of the new motor.

Fan with newly developed
ARCTIC motor
Fan with regular motor and
anti-vibration-rubber
Fan with regular motor
without vibration absorption

Noise Level

5 % vibration from
commutation

50 % vibration from
commutation

100 % vibration from
commutation

 

Extended Life Span

A 10 °C lower motor temperature roughly doubles the life span of a fan.
The new ARCTIC motor has a four times longer service life through its low coil temperature.
Consequently, we have extended the warranty to 10 years.

P14 PWM
(New ARCTIC Motor)
No-Name 140 mm Fan
(Typical DC-Motor)

Coil Temperature @ 22 °C Ambient Temperature

35.3 ℃
54.5 ℃
 
 

200 to 1700 RPM
regulated via PWM

Thanks to the 4-pin connector, the RPM can be regulated in a broad spectrum via PWM.
In this way, noise is kept at a minimum while maximum cooling performance is guaranteed when needed.

 

High Quality Bearing

Thanks to an alloy/lubricant combination developed in Germany, friction within the bearing is reduced and greater efficiency is achieved. As a result, there is less heat development as well as less bearing noise, which means you can enjoy a longer service life from your fan.

 

Two Way Installation

Push warm air out of the case

Pull cool air into your case

© Faroll 版權所有

Faroll 法奧, 荔枝角永康街23至27號安泰工業大廈3樓B座333室
(+852) 3426 4501
[email protected]